Applications tips: There are two major factors influencing the work with coatings - temperature and humidity. The higher the temperature and/or humidity, the quicker the coatings flashes and cures. The initial bonding time of MJMC ceramic coatings with the surface is only a few seconds. Don't wait, wipe off immediately. Work in small sections, split panels in maximum 60x60cm areas.
Never work in direct sunlight/outside.
Ensure the area you work in well ventilated.
Use correct lighting, apply the coating using reflected light.
Use an appropriate amount of quality microfibre towels for wipe off. 2 microfibres are a minimum, swap sides of the MF during work.
Ensure the car stays in stable conditions without the risk of rainfall or rapid humidity
changes.
FACTS AND MAINTENANCE: A dry coating is not a cured coating. Once the car is leaving your studio after a coating install, the coating is dry, which refers to 90% of fully cured. The full curing process might take up to 4 weeks, where the first week is crucial. This time is necessary for all solvents to evaporate and the coating to build its full structural integrity, hardness and resistance. This results in the following rules:
Leave the car in the studio for at least 12 hours after coating.
Never allow car to leave with a fresh coating.
Do not to wash the car for the first 7-14 days (depends on temperature and humidity)
Maintenance you coating with right tools and chemicals.
Box contain: 1) m2 hard coating 15 мл 2) Sponge pad 3) Gloves
By clicking the button, you agree to the processing of personal data
